<< Click to Display Table of Contents >> Navigation:  Appendix > Anti-Tamper Alarm

The VDP103 has an anti-tamper alarm built in.

The alarm is triggered if the VDP103 is moved when powered up but may also triggered if the VDP103 is not vertical.

To avoid this the top of the VDP103 just needs to be raised slightly.

The alarm will reset after one minute but may retrigger if still not vertical or if moved.

 

Disabling the Anti-Tamper Alarm

Hold down the Call button when powering on (five beeps) then release the call button.

Anti-Tamper is now disabled until the power is cycled.