<< Click to Display Table of Contents >> Navigation: Appendix > Default Settings |
Admin PIN |
999999 |
Entry Pin |
No Default |
Unlock Mode |
Card or PIN |
Unlock Time |
2s |
Safe Mode |
Off |
Defaulting
To default the settings in admin mode press 099# a single long beep indicates success.
This will default settings including the admin password and remove the Entry PIN but will not delete the programmed cards, fobs or user PIN's.
If the admin password is forgotten then a hard reset will have to be carried out.
This is achieved by holding down both the ENTER and ESC buttons whilst powering on. The VDP103 will beep three times to show it has been defaulted.
This will not have removed the programmed cards, fobs or user PIN's.
To remove all programmed cards, fobs or user PIN's see Deleting All Cards and Fobs