Overview > Installation Guidlines

1.Never operate the equipment using an unspecified power supply.

2.Do not install the equipment in a dusty or damp area. Avoid a humid environment.

3.Keep the surface of the equipment clean and dry. Use soft damp cloth to clean the outer case of recorder (do not use liquid aerosol cleaners.)

4.If the system clock fails to work, power down the recorder, remove the top of the case and replace the standard 3V lithium battery on the main board.

5.Always install the recorder in a place with good ventilation ensuring that the ventilation slots are not covered and that there is a good flow of air around the recorder. Due to the heat produced especially by the Hard Drive/s, reducing ventilation can reduce life of the recorder components and the Hard Drive/s.

6.The power adaptor on the recorder must only be used to power one recorder because connecting additional equipment can cause the recorder to reboot due to insufficient power.