VDP102 - Quick Start Guide
|
The VDP102 is a modern design video door camera with a backlit call button, IR LED and extra wide angle 2.4mm lens for a 110° viewing angle. Rust and weatherproof this unit is well built with anti-vandal properties. It is supplied with a rain guard for more exposed installations and an optional angled bracket for fitting in the best possible position. |
Full Instruction Manual
|
User Information
•There are no user serviceable parts, opening or attempting to repair the product will void the warranty.
•Do not install or use the device if the wires connected are damaged or have been subjected to water ingress.
•Shut off all power to the access control system before wiring this device.
•Maintain a clean and safe environment at all times
All of the DoorKnox cameras have connection cables terminated into the same 7 colour coordinated wires. 4 wires are used to connect to the monitor and then 2 of the 3 remaining wires are used to connect to an electronic door lock.
The common (COM) wire is always used along with either the normally open (NO) or normally closed (NC) wire depending on the lock type.
|
|
Monitor Connections
|
Mounting Recommended to be installed between 150 to 160cm above the floor (About 5 feet), it should not be mounted in direct sunlight.
|
Image Sensor |
1/3" CMOS |
Resolution |
800 TVL |
Lens Type |
2.4mm Pinhole Fixed Lens |
Viewing Angle |
110° Wide Angle |
InfraRed LEDs |
3 |
Input Voltage |
12V DC |
Consumption |
200mA |
IP Rating |
IP64 |
Mounting Options |
Surface / Angle (Supplied) |
Finish |
Silver & Black Gloss |
Build |
Rust Proof Aluminium Alloy |
Dimensions |
128 x 49x 41mm (including rain guard) |